PTS-001 'Pit Bull' - Hook Load / Dead Line Sensor |
Part Number: PTS - 001
4...20 mA 2 wire current loop output Zone 0 Ex ia IIC Certified For up to 2.5" Cables Mechanics rated up to 200,000 lbs MS6 Connector Standard
Certified to ATEX, IECEx and CSA
Field trials successful on three drilling rigs in Germany and Brazil!
Photo shows unit attached to 1" cable. Different inserts, magnetically attached to torque pin are used for different cable diameters.
A 3/4" Hex ratchet is provided and locked into place, though if it does go missing, any 3/4" Hex wrench will do the job. |
Technical Data | Connection Options | ||
Operating temp: | - 40 ...+ 60 degrees C | MS6, MS7, MS10 (available with junction box as well) | |
- 40 ...+ 140 degrees F | + Loop | Pin A | |
Load Cell Certification: | ATEX, CSA and IECEx | - Loop | Pin D |
Weight: | 22 lbs (10 kg) | ||
Protection: | IP 66 / X7 M | Installation | |
Material Load Cell: | Stainless Steel | Installed on the deadline side | |
Material Chassis: | Aluminum | Output is linearly proportional to tension on deadline | |
Material Clamp: | Stainless Steel | For 0.75â to 2.5â cable diameters | |
Output Tolerance: | 0.25% of full scale | ||
Calibration Error: | Under 5% | Output Limits (always linear) | |
Temp Effects: | Full shift 0.035%/10C | At min weight, the output is 4mA (point set by user) | |
At max weight, the output is 20mA (point set be user) | |||
Advantages | ![]() | ||
-Easy MS6, MS7 or MS10 connection | |||
-Easy to use clamp on design | |||
-Fully interchangeable with existing units | |||
-Field replaceable load cell, in the event of a | |||
failure, only the actual load cell is replaced | |||
Certification | |||
IP 66 and Ex ia IIC | |||
From Load Cell | |||
Best suited to work with the following MTL | |||
isolator: MTL5541 |
Installation Manual:
Hook load sensor installation manual
Dimensions:
504, Ghanshyam Enclave, Lalji Pada, Kandivali Link Road, Kandivali (West), Mumbai, Maharashtra, 400067, India
Phone :+918037304378